The general procedure for making standard products is as follows.
Please use this as a reference when ordering.
  1. Make the depth of the net approximately 30cm to 40cm shorter than the pipe dimensions.This is because it is dangerous if the ball hits the pipe behind the front net and bounces back.
  2. Make the height of the net approximately 30cm longer than the pipe dimensions.This is to prevent the ball from coming out from below, so hang it about 30cm on the ground.
  3. Make the width of the net the same length as the outside dimensions of the pipe. (Inner dimensions are also fine.) To be exact, it is the inner dimensions of the pipe (the net is attached to the inside of the pipe).
    *If you are installing it by yourself, it seems that many people will not be able to tighten it properly if they make it according to the inner dimensions.
    This is because it will sag slightly even if you pull it to install it.
  4. Front net/Double the part of the net that touches the front net. The area around the front net is often hit by balls and is easily torn, so for safety reasons, it is double layered. The dark green part in the image below will be doubled.

GET TO KNOW ABOUT OUR NETTING

Other Introductions

1. KNITTING METHODS

2. TAILORING METHODS

3. Eye netting

4. PROCESSING METHOD 1: FLAT NET

5. PROCESSING METHOD 2: DEFORMED/BOX-SHAPED NET

6. NET PRODUCTION PROCESS

7. HARDWARE (RINGS ETC.)

8. THE GOLF BOX NET

9. IMPORTANT PRECAUTIONS FOR SPORTSNET USERS